Digi LR54 User Manual page 631

Hide thumbs Also See for LR54:

Table of Contents

5. For Location update interval, type the amount of time to wait between polling location

sources for new location data. The default is ten seconds.

Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the

format number{w|d|h|m|s}.

For example, to set Location update interval to ten minutes, enter 10m or 600s.

6. For information about configuring Location sources, see the following:

a. To accept location information from an external location-enabled server, see

device to accept location messages from external

b. To set a static location for the device, see

If multiple location sources are enabled at the same time, the device's location will be

determined based on the order that the location sources are listed here.

7. For information about configuring Destination servers, see

8. For information about configuring Geofence, see

9. Click Apply to save the configuration and apply the change.

Command line

1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54

local command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Enable or disable the GNSS module:

To enable the module:

(config)> service location gnss true

To disable the module:

(config)> service location gnss false

4. Set the amount of time that the LR54 device will wait before polling location sources for

updated location data:

(config)> service location interval value

where value is any number of hours, minutes, or seconds, and takes the format number

For example, to set interval to ten minutes, enter either 10m or 600s:

LR54 User Guide

Configure the device to use a user-defined static

Forward location information to a

Location information

Configure the