Digi LR54 User Manual page 101

Interfaces
e. For Add Test Target, click .
f. For Test type, select Ping test.
g. For Ping host, type 43.66.93.111.
h. For Ping payload size, type 256.
4. Repeat the above step for WWAN to enable SureLink on that interface.
5. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure SureLink on WAN1:
a. Set the interval to ten seconds:
(config)> network interface wan1 ipv4 surelink interval 10s
(config)>
b. Delete the existing test targets:
(config network interface wan1> del ipv4 surelink target 0
(config network interface wan1> del ipv4 surelink target 1
(config network interface wan1)>
c. Add a test target:
(config)> add network interface wan1 ipv4 surelink target end
(config network interface wan1 ipv4 surelink target 0)>
d. Set the probe type to ping:
LR54 User Guide
Wide Area Networks (WANs)
101