Digi LR54 User Manual page 162

Interfaces
5. Create a new bridge:
a. For Add Bridge, type LAN2 and click .
b. Add the ETH3 and Digi AP (Wi-Fi2) devices to the bridge:
i. Click to expand Devices.
ii. For Add Device:, click .
iii. For Device, select Ethernet: ETH3.
iv. For Add device, click  again and select WiFi access point: Digi AP (Wi-Fi2).
6. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Display a list of devices currently configured for the LAN1 bridge:
(config)> show network bridge lan1 device
0 /network/device/eth2
1 /network/device/eth3
2 /network/device/eth4
3 /network/wireless/ap/digi_ap1
4 /network/wireless/ap/digi_ap2
(config)>
4. Remove devices from the LAN1 bridge that will be used by other interfaces in this
configuration.
LR54 User Guide
Local Area Networks (LANs)
162