Digi LR54 User Manual page 929

System administration
3. In the Erase configuration section, click ERASE.
4. Click CONFIRM.
5. After resetting the device:
a. Connect to the LR54 by using the serial port or by using an Ethernet cable to connect the
LR54 LAN1 port to your PC.
b. Log into the LR54:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
Note If your device was manufactured prior to the release of firmware version 19.11.x, the
default user name may be root.
For Wi-Fi enabled models, when you first log into the WebUI or the command line, you will
be required the change the SSIDs and pre-shared keys (passwords) for the preconfigured
Wi-Fi access points before you can save any configuration changes. See
SSIDs and pre-shared keys for the preconfigured Wi-Fi access points
c. (Optional) Reset the default password for the admin account. See
password for the admin user

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the following:
> system factory-erase
3. After resetting the device:
a. Connect to the LR54 by using the serial port or by using an Ethernet cable to connect the
LR54 LAN1 port to your PC.
LR54 User Guide
Erase device configuration and reset to factory defaults
for further information.
Reset default
for instructions.
Change the default
929