Dynamic Dns - Digi LR54 User Manual

Routing
2. At the Admin CLI prompt, type
> show route
Destination
Interface
------------------------
--- ------------------------
default
10.1.14.25
/network/device/eth1
10.1.14.27
/network/device/eth1
10.1.25.0/24
/network/device/eth1
127.0.0.0/8
/network/device/loopback
fd00:2704::1
fd00:2704::/64
fd00:2704::/48
2147483647
fe80::204:f3ff:fe80:e231
fe80::204:f3ff:ff80:c525
fe80::/64
fe80::/64
default
default
IPv4 Route
----------
wan1
wwan1
IPv6 Route
----------
wan1
wwan1
>
You can limit the display to only IPv4 entries by using show route ipv4, or to IPv6 entries by
using show route ipv6. You can also display more information by adding the verbose option
to the show route and show route ip_type commands.
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Dynamic DNS

The Domain Name System (DNS) uses name servers to provide a mapping between computer-
readable IP addresses and human-readable hostnames. This allows users to access websites and
personal networks with easy-to-remember URLs. Unfortunately, IP addresses change frequently,
LR54 User Guide
show route:
Gateway
------------------------
10.1.21.1
10.1.21.1
10.1.21.1
fe80::204:f3ff:fe80:e231
fe80::204:f3ff:fe80:e231
fe80::204:f3ff:fe80:e231
fe80::204:f3ff:fe80:e231
Load Balance (%)
----------------
75.0
25.0
Load Balance (%)
----------------
75.0
25.0
Dynamic DNS
Source Metric
----------- -------
1
10.1.21.99 1
10.1.21.99 1
10.1.21.99 1
127.0.0.1
1
1
1
1
256
256
1
1024
403