Digi LR54 User Manual page 164

Interfaces
c. the Digi AP (Wi-Fi2) access point to the bridge:
(config network bridge LAN2)> add device end
/network/wireless/ap/digi_ap2
(config network bridge LAN2)>
d. Use the show command again to verify that the LAN2 bridge now has two devices, ETH3
and Digi AP (Wi-Fi2):
(config network bridge LAN2)> show network bridge lan2 device
0 /network/device/eth3
1 /network/wireless/ap/digi_ap2
(config network bridge LAN2)>
7. Save the configuration and apply the change:
(config network bridge LAN2)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
LR54 User Guide
Local Area Networks (LANs)
164