Digi LR54 User Manual page 296

Wi-Fi
a. Click Configuration > Network > Interfaces.
b. For Add interface, type a name for the LAN and click .
c. For Zone, select LAN2_isolation_zone.
d. For Device, select Wi-Fi access point: Digi AP (Wi-Fi2).
e. Click to expand IPv4.
f. For Address, type an IP address and subnet for the LAN.
g. Click to expand DHCP server.
h. Enable the DHCP server.
5. Remove the Digi AP (Wi-Fi2) access point from the LAN1 bridge:
a. Click Network > Bridges > LAN1.
b. Click the down arrow () next to the the Digi AP (Wi-Fi2) access point and select Delete.
6. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure a new access point:
a. Create a new access point:
(config)> add network wifi ap new_AP
(config network wifi ap new_AP)>
New access points are enabled by default.
LR54 User Guide
Isolate Wi-Fi clients
296