Digi LR54 User Manual page 279

Wi-Fi
Allowed values are any number of days, hours, minutes, or seconds, and take the format
number{d|h|m|s}.
For example, to set Group rekey interval to ten minutes, enter 10m or 600s.
Increasing the time between rekeys can improve connectivity issues in noisy environments. To
disable group rekeys, set to 0. This will allow any client that has previously connected to see
all broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
11. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
Network (LAN)
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
12. Click Apply to save the configuration and apply the change.

Command line
Configure a new Access point
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new access point:
(config)> add network wifi ap new_AP
(config network wifi ap new_AP)>
New access points are enabled by default.
4. Set the Wi-Fi radio for the new access point:
a. Show available radios:
(config network wifi ap new_AP)> radio ?
Radio: The Wi-Fi radio to run this access point on.
Format:
wifi1
wifi2
Current value:
(config network wifi ap new_AP)>
b. Set the appropriate radio:
(config network wifi ap new_AP)> radio wifi1
(config network wifi ap new_AP)>
LR54 User Guide
and Configure a bridge for more information.
Configure a Wi-Fi access point with personal security
Configure a Local Area
279