Digi LR54 User Manual page 834

Hide thumbs Also See for LR54:

Table of Contents

User authentication

Command line

1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54

local command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. At the config prompt, type:

(config)> auth idle_timeout value

where value is any number of weeks, days, hours, minutes, or seconds, and takes the format

number{w|d|h|m|s}.

For example, to set idle_timeout to ten minutes, enter either 10m or 600s:

(config)> auth idle_timeout

4. Save the configuration and apply the change:

(config)> save

Configuration saved.

5. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

LR54 User Guide

Set the idle timeout for LR54 users