Enable Service Discovery (Mdns) - Digi LR54 User Manual

Services
a. Type ... to return to the root of the configuration:
(config network interface eth_bonding_interface)> ...
(config)>
b. Disable the interfaces:
(config)> network interface wan1 enable false
(config)> network interface lan1 enable false
(config)>
In some cases, the device may be a part of a bridge, in which case you should remove the
device from the bridge. For example:
a. Determine the index number of the device:
(config)> show network bridge lan1 device
0 /network/device/eth2
1 /network/device/eth3
2 /network/device/eth4
3 /network/wifi/ap/digi_ap1
4 /network/wifi/ap/digi_ap2
(config)>
b. Use the index number to delete the device from the bridge:
(config)> del network bridge lan1 device 0
(config)>
See Configure a bridge
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Enable service discovery (mDNS)

Multicast DNS mDNS is a protocol that resolves host names in small networks that do not have a DNS
server. You can enable the LR54 device to use mDNS.

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
LR54 User Guide
for more information.
Enable service discovery (mDNS)
697