Digi LR54 User Manual page 321

Hotspot

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the hotspot:
(config)> network hotspot hotspot enable true
(config)>
4. Enable the hotspot access points:
(config)> network ap digi_hotspot_ap1 enable true
(config)> network ap digi_hotspot_ap2 enable true
(config)>
5. Enable the hotspot bridge:
(config)> network bridge hotspot_bridge enable true
(config)>
6. Enable the hotspot LAN:
(config)> network interface lan_hotspot enable true
(config)>
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
LR54 User Guide
Hotspot configuration
321