Digi LR54 User Manual page 167

Interfaces
b. Configure Digi AP (Wi-Fi2):
i. Click Network > Wi-Fi > Access points > Digi AP (Wi-Fi2).
ii. Click Enable.
iii. For SSID, type Example2.
iv. For Pre-shared key, enter a password that clients will use to connect to this access
point.
7. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a new network interface named LAN2:
(config)> add network interface LAN2
(config network interface LAN2)>
4. Configure the device for the LAN2 interface:
a. Enter device ? to view available devices and the proper syntax.
(config network interface LAN2)> device ?
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/eth3
/network/device/eth4
LR54 User Guide
Local Area Networks (LANs)
167