Serial port
4. Set the stop bits used by the device to which you want to connect:
(config)>path-paramstopbits bits
(config)>
5. Set the type of flow control used by the device to which you want to connect:
(config)>path-paramflow value
(config)>
where value is one of:
none
n
rts/cts
n
xon/xoff
n
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show serial status and statistics
To show the status and statistics for the serial port:
Web
1. Log into the LR54 WebUI as a user with Admin access.
2. On the main menu, click Status
3. Under Connections, click Serial.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show serial
> show serial
Label
--------
Serial 1
>
LR54 User Guide
command:
Port
Enable
Mode
-----
------
-----
port1
true
login
Show serial status and statistics
Baudrate
--------
115000
255