Locate The Device By Using The Find Me Feature - Digi LR54 User Manual

Hide thumbs Also See for LR54:

Table of Contents

System administration

c. Select the file from your local file system.

Command line

1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54

local command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. Enter the following:

> system backup / type custom-defaults

Backup saved as /opt/custom-default-config.bin

3. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Locate the device by using the Find Me feature

Use the Find Me feature to cause LEDs on the device to blink, which can help you to identify the

specific device.

To use this feature:

1. Log into the LR54 WebUI as a user with Admin access.

2. On the menu, click System. Under Administration, click Find Me.

A notification message appears, noting that the LED is flashing on the device. Click the x in the

message to close it.

3. On the menu, click System again. Ablue circle next to Find Me is blinking, indicating that the

Find Me feature is active.

LR54 User Guide

Locate the device by using the Find Me feature