Digi LR54 User Manual page 971

Monitoring
(config monitoring wifi_scanner push server 0)> port port
(config monitoring wifi_scanner push server 0)>
f. Set the protocol that the device should use to upload the Wi-Fi scanner results to the
remote server:
(config monitoring wifi_scanner push server 0)> protocol value
(config monitoring wifi_scanner push server 0)>
where value is either http or tcp.
g. Enable compression to compress the data being sent to the remote host:
(config monitoring wifi_scanner push server 0)> compress on
(config monitoring wifi_scanner push server 0)>
The default is off (compression disabled).
h. Repeat for additional remote hosts.
10. Enable the device to open an SSH port that remote hosts can access:
(config)> monitoring wifi_scanner ssh enable true
(config)>
11. (Optional) Set the number of the port that the Wi-Fi scanner will use. The default is 3101.
(config)> monitoring wifi_scanner ssh port port
(config)>
12. Configure access control:
To limit access to specified IPv4 addresses and networks:
n
(config)> add wifi scanner ssh acl address end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
(config)> add wifi scanner ssh acl address6 end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
LR54 User Guide
A single IP address or host name.
A network designation in CIDR notation, for example, 192.168.1.0/24.
any: No limit to IPv4 addresses that can access the SSH service.
A single IP address or host name.
A network designation in CIDR notation, for example, 2001:db8::/48.
any: No limit to IPv6 addresses that can access the SSH service.
Enable the Wi-Fi scanner
971