Digi LR54 User Manual page 361

Hotspot

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show hotspot
> show hotspot
Hotspot
-----------
hotspot
new_hotspot
>
3. Enter the show hotspot name hotspot_name command at the Admin CLI prompt to display
information about clients connected to a specific hotspot:
> show hotspot name hotspot
MAC Address
Idle/max sec
-----------------
----- ------------------
8C-2D-2D-C8-41-AA
0/0
E5-8A-FC-D3-DC-7E
0/0
>
4. Enter the show hotspot ip ip_address command at the Admin CLI prompt to display
information about clients connected to a specific hotspot:
> show hotspot ip hotspot 10.1.0.101
MAC Address
Idle/max sec
-----------------
----- ------------------
8C-2D-2D-C8-41-AA
0/0
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
LR54 User Guide
command at the Admin CLI prompt:
Enabled Status Device
------- ------ --------------
true up hotspot_bridge
false down new_hotspot_ap
IP Address Auth
%/max up bandwidth
---------- ----
--------------------
10.1.0.101 yes
0/0
10.1.0.100 no
0/0
IP Address Auth
%/max up bandwidth
---------- ----
--------------------
10.1.0.101 yes
0/0
Show hotspot status and statistics
Username Duration/max sec
%/max down bandwidth
-------- ----------------
mariev 0/0
- 0/0
Username Duration/max sec
%/max down bandwidth
-------- ----------------
mariev 0/0
-------
0/0
0/0
-------
0/0
361