Digi LR54 User Manual page 330

Hotspot
4. Click the  to add a new device.
5. By default, For Device, select the appropriate Ethernet port.
By default, the ETH1 device is configured as the device for the WAN1 interface, and ETH2,
ETH3, and ETH4 are configured as devices in the LAN1 bridge, which is used by the LAN1
interface. As a result, when you add an Ethernet port to the hotspot, you may need to
reconfigure the Ethernet port configuration for other interfaces. For example, to remove the
ETH4 port from the LAN1 bridge:
a. Click Network > Bridges > LAN1 > Devices.
b. Click the ... menu icon next to the Ethernet: ETH4 device entry and select Delete.
6. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
LR54 User Guide
Hotspot configuration
330