Digi LR54 User Manual page 305

Wi-Fi
5. Configure the Wi-Fi network that the client will use:
a. Set the SSID of the access point that the client will use to connect to the Wi-Fi network:
(config network wifi client new_client)> ssid 0 ssid value
(config network wifi client new_client)>
where value is the SSID of the access point.
b. Set the encryption type for the access point:
(config network wifi client new_client)> ssid 0 encryption type value
(config network wifi client new_client)>
where value is the type of encryption used by the access point. Allowed values are:
n
n
n
n
n
n
n
n
c. If the type of encryption is set to:
n
n
LR54 User Guide
none: no encryption.
owe: WPA3 Enhanced Open, which uses Opportunistic Wireless Encryption (OWE)
technology to provide encryption for Wi-Fi networks that do not use password
protection.
psk: WPA personal encryption.
mixedpsk: Uses both WPA and WPA2 personal encryption.
psk2: WPA2 personal encryption.
psk2sae: Uses WPA2-PSK/WPA3-AES mixed mode.
sae: Uses WPA3 Personal mode.
wpa2: WPA2 enterprise encryption.
psk, mixedpsk, psk2, psk2sae, or sae, set the password that the client will use to
connect to the access point:
(config network wifi client new_client)> ssid 0 encryption key_
psk2 password
(config network wifi client new_client)>
wpa2:
i. Set the Extensible Authentication Protocol (EAP):
(config network wifi client new_client)> ssid 0 encryption
eap_type value
(config network wifi client new_client)>
where value is one of:
peap: Username/password authentication. If peap is set:
l
i. Set the username:
(config network wifi client new_client)> ssid 0
encryption id_wpa2 username
(config network wifi client new_client)>
Configure a Wi-Fi client and add client networks
305