Digi LR54 User Manual page 786

User authentication
l
l
The default is Full access.
Serial access
n
Interactive shell access
n
Shell access is not available if the Allow shell parameter has been disabled. See
shell access
6. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable access rights for the group. For example:
Admin access:
n
l
LR54 User Guide
Full access provides users of this group with the ability to manage the LR54 device
by using the WebUI or the Admin CLI.
Read-only access provides users of this group with read-only access to the WebUI
and Admin CLI.
for more information about the Allow shell parameter.
To set the access level for Admin access of the admin group:
(config)> auth group admin acl admin level value
(config)>
where value is either:
Authentication groups
Disable
786