Digi LR54 User Manual page 246

Serial port
4. Set the mode:
(config)> serial port1 mode udp
(config)>
5. (Optional) Set a label that will be used when referring to this port.
(config)>serial port1 label label
(config)>
6. Set the baud rate used by the device to which you want to connect:
(config)>serial port1 label baudrate rate
(config)>
7. Set the number of data bits used by the device to which you want to connect:
(config)>serial port1 label databits bits
(config)>
8. Set the type of parity used by the device to which you want to connect:
(config)>serial port1 label parity parity
(config)>
Allowed values are:
even
n
odd
n
none
n
The default is none.
9. Set the stop bits used by the device to which you want to connect:
(config)>serial port1 label stopbits bits
(config)>
10. Set the type of flow control used by the device to which you want to connect:
(config)>serial port1 label flow type
(config)
Allowed values are:
none
n
rts/cts
n
xon/xoff
n
The default is none.
11. (Optional) Configure data framing:
a. Enable data framing:
(config)>serial port1 framing enable true
(config)
LR54 User Guide
Configure UDP serial mode
246