Digi LR54 User Manual page 335

Hotspot
d. Create an interface for the bridge:
i. Click Configuration > Network > Interfaces.
ii. For Add Interface, create a new interface and click .
iii. For Device, select the bridge created above.
iv. Click to expand IPv4.
v. For Address, enter an IP address and subnet mask for the LAN. This IP address must
be unique from all other interfaces.
Note
configured during hotspot configuration.
5. Click Network > Hotspots.
6. For Add Hotspot, enter a name for the hotspot and click .
The new hotspot configuration appears.
7. Hotspots are enabled by default when they are created. To disable, toggle off Enable hotspot.
8. For Zone, leave at the default setting of hotspot. The hotspot firewall zone provides the
necessary firewall rules for hotspot functionality.
9. For Device, select an access point, and Ethernet port, or a bridge.
10. For Authentication Mode, select one of the following:
Click-through: Requires each user to accept the terms and conditions.
n
Local shared password: Requires each user to enter a password. This password is
n
validated locally on the LR54 device, and the password is the same for all users.
See
about configuring hotspot for local shared password authentication.
LR54 User Guide
This IP address is not the IP address of the hotspot. The hotspot IP address is
Configure the hotspot to use local shared password authentication
Hotspot configuration
for information
335