L2Tpv3 Ethernet; Configure An L2Tpv3 Tunnel - Digi LR54 User Manual

Virtual Private Networks (VPN)
>
3. To display details about a specific tunnel:
> show l2tp lns name lns_test2
lns_test2 L2TP Access Concentrator Status
------------------------------------
Enabled
Status
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

L2TPv3 Ethernet

Your LR54 device supports Layer 2 Tunneling Protocol Version 3 (L2TPv3) static unmanaged Ethernet
tunnels.

Configure an L2TPv3 tunnel

Your LR54 device supports Layer 2 Tunneling Protocol Version 3 (L2TPv3) static unmanaged Ethernet
tunnels.
Required configuration items
A name for the L2TPv3 tunnel.
n
Enable the tunnel.
n
The remote endpoint IP address.
n
The local endpoint IP address.
n
The session ID.
n
The peer session ID.
n
Additional configuration items
Encapsulation type. If UDP is selected:
n
The ID for the tunnel.
l
The ID of the peer's tunnel.
l
Determine whether to enable UDP checksum.
l
The session cookie.
n
The peer session cookie.
n
The Layer2SpecificHeader type.
n
The Sequence numbering control.
n
LR54 User Guide
: true
: pending
L2TPv3 Ethernet
569