Digi LR54 User Manual page 170

Interfaces

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network
> show network
Interface
----------------
defaultip
defaultlinklocal
lan1
lan1
loopback
wan1
wan1
wwan
wwan
>
3. Additional information can be displayed by using the
> show network verbose
Interface
Weight
----------------
----
defaultip
defaultlinklocal
lan1
lan1
loopback
wan1
wan1
wwan
wwan
>
4. Enter show network interface name at the Admin CLI prompt to display additional
information about a specific LAN. For example, to display information about LAN1, enter show
network interface lan1:
> show network interface lan1
lan1 Interface Status
LR54 User Guide
command at the Admin CLI prompt:
Proto Status Address
----- ------- -------------------------------
IPv4 up 192.168.210.1/24
IPv4 up 169.254.100.100/16
IPv4 up 192.168.2.1/24
IPv6 up fd00:2704::1/48
IPv4 up 127.0.0.1/8
IPv4 up 10.10.10.10/24
IPv6 up fe00:2404::240:f4ff:fe80:120/64
IPv4 up 10.200.1.101/30
IPv6 down
Proto Status Type
----- ------- ------
IPv4 up static
IPv4 up static
IPv4 up static
IPv6 up static
IPv4 up static
IPv4 up dhcp
IPv6 up dhcp
IPv4 up modem
IPv6 down modem
Local Area Networks (LANs)
show network verbose command:
Zone Device
-------- --------
setup lan1
setup lan1
internal lan1
internal lan1
loopback loopback
external wan1
external wan1
external wwan1
external wwan1
Metric
------ --
10 10
0 10
5 10
5 10
0 10
1 10
1 10
3 10
3 10
170