Digi LR54 User Manual page 347

Hide thumbs Also See for LR54:

Table of Contents

Create a new hotspot

4. During hotspot configuration, for Authentication mode, select Local shared password .

5. For Local shared password, type the password that all users will be required to enter to

authentication with the hotspot.

6. Click Apply to save the configuration and apply the change.

Configure hotspot for local shared password authentication from the Command line

1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54

local command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

Create a new hotspot

4. Set the authentication mode to local-shared-password:

(config)> network hotspot hotspot_name auth local-shared-password

5. Set the password that all users will be required to enter to authentication with the hotspot:

(config)> network hotspot hotspot_name local_shared_password password

6. Save the configuration and apply the change:

(config)> save

Configuration saved.

7. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

LR54 User Guide

Enable hotspot using the default

Hotspot configuration

configuration.