Digi LR54 User Manual page 273

Wi-Fi
4. Set the Wi-Fi radio for the new access point:
a. Show available radios:
(config network wifi ap new_AP)> radio ?
Radio: The Wi-Fi radio to run this access point on.
Format:
wifi1
wifi2
Current value:
(config network wifi ap new_AP)>
b. Set the appropriate radio:
(config network wifi ap new_AP)> radio wifi1
(config network wifi ap new_AP)>
5. Set the SSID for the Wi-Fi access point. Up to 32 characters are allowed.
(config network wifi ap new_AP)> ssid my_SSID
(config network wifi ap new_AP)>
SSID broadcasting is enabled by default for new access points.
6. Set the security for the access point to an open security method:
(config network wifi ap new_AP)> encryption type value
(config network wifi ap new_AP)>
where value is either:
none: No encryption is used.
n
owe: Uses WPA3 Enhanced Open, which uses Opportunistic Wireless Encryption (OWE)
n
technology to provide encryption for Wi-Fi networks that do not use password
protection.
Note
have WPA3 capabilities.
7. (Optional) Determine whether to prevent clients that are connected to this access point from
communicating with each other:
(config)> network wifi ap digi_ap1 isolate_clients true
(config)>
See Isolate Wi-Fi clients
access points from communicating with each other.
8. (Optional) Set the amount of time to wait before changing the group key.
The group key is shared by all in clients of the access point, and after a client has
disconnected, it will be able to use the group key to decrypt broadcast packets until the key is
changed.
LR54 User Guide
Only select owe if you know that all Wi-Fi clients connecting to this device will
for information about how to prevent clients connected to different
Configure an open Wi-Fi access point
273