Digi LR54 User Manual page 900

Containers
3. Click System > Containers.
4. For Add Container, type the name of the container and click .
The Container configuration window is displayed.
New containers are enabled by default. To disable, toggle off Enable.
5. Clone DAL is enabled by default. This allows the container to use the device's system libraries.
6. Enable Virtual Network if the container should have network access:
a. Select a Network Bridge Device that will provide access to the container.
b. (Optional) Enter a static IP Address and netmask for the container. This must be a valid IP
address for the bridge, or, if left blank, a DHCP server can assign the container an IP
address.
c. (Optional) For Gateway, type the IP address of the network gateway.
7. Click to expand Serial ports to sssign serial ports that the container will have access to.
a. For Add Port, click .
b. For Port, select the serial port.
8. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
LR54 User Guide
Configure a container
900