Digi LR54 User Manual page 304

Wi-Fi
f. Click to expand Scan frequencies list. You must add one or more frequency to scan:
i. Click  to add a scan frequency.
ii. Select a frequency.
iii. Repeat for additional frequencies.
g. To add a channel, click Add Scan frequency and select the appropriate channel.
8. Click Apply to save the configuration and apply the change.
After you configure a Wi-Fi client, you must assign the Wi-Fi client to a WAN. See
(WANs) and Wireless Wide Area Networks (WWANs)

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new Wi-Fi client:
(config)> add network wifi client new_client
(config network wifi client new_client)>
New clients are enabled by default.
4. Set the Wi-Fi radio for the new client:
a. Show available radios:
(config network wifi client new_client)> .. .. radio ?
Additional Configuration
---------------------------------------------------------------------
----------
wifi1
wifi2
(config network wifi client new_client)>
b. Set the appropriate radio:
(config network wifi client new_client)> radio wifi1
(config network wifi client new_client)>
LR54 User Guide
Configure a Wi-Fi client and add client networks
for further information.
Wi-Fi1 radio
Wi-Fi2 radio
Wide Area Networks
304