Digi LR54 User Manual page 651

Services
8. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a geofence:
(config)> add service location geofence name
(config service location geofence name)>
where name is a name for the geofence. For example:
(config)> add service location geofence test_geofence
(config service location geofence test_geofence)>
The geofence is enabled by default. To disable:
(config service location geofence test_geofence)> enable false
(config service location geofence test_geofence)>
4. Set the amount of time that the geofence should wait between polling for updated location
data:
(config service location geofence test_geofence)> update_interval value
(config service location geofence test_geofence)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the format
number{w|d|h|m|s}.
For example, to set update_interval to ten minutes, enter either 10m or 600s:
(config service location geofence test_geofence)> update_interval 600s
(config service location geofence test_geofence)>
LR54 User Guide
v. (Optional) For Maximum memory, type the maximum amount of system
memory that will be available for the script and it spawned processes.
Allowed values are any integer followed by one of the following:
b|bytes|KB|k|MB|M|GB|G|TB|T.
For example. the allocate one megabyte of memory to the script and its
spawned processes, type 1MB or 1M.
vi. Sandbox is enabled by default. This prevents the script from adversely
affecting the system. If you disable Sandbox, the script may render the system
unusable.
vii. Repeat for any additional actions.
Location information
651