Digi LR54 User Manual page 208

Interfaces

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create the bridge:
(config)> add network bridge my_bridge
(config network bridge my_bridge)>
4. Bridges are enabled by default.
To disable:
n
(config network bridge my_bridge)> enable false
(config network bridge my_bridge)>
To enable if it has been disabled:
n
(config network bridge my_bridge)> enable true
(config network bridge my_bridge)>
5. Add devices to the bridge:
a. Determine available devices:
(config network bridge my_bridge)> .. .. interface lan1 device ?
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/eth3
/network/device/eth4
/network/device/loopback
/network/bridge/hotspot_bridge
/network/bridge/lan1
/network/wireless/ap/digi_ap1
/network/wireless/ap/digi_ap2
/network/wireless/ap/digi_hotspot_ap1
/network/wireless/ap/digi_hotspot_ap2
Default value: /network/bridge/lan1
Current value: /network/bridge/lan1
(config network bridge my_bridge)>
LR54 User Guide
Bridging
208