Digi LR54 User Manual page 342

Hotspot
7. Set an access point, and Ethernet port, or a bridge for the hotspot's device:
a. Determine available devices:
(config network hotspot new_hotspot)> device ?
Device: Device to use for this hotspot interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/eth3
/network/device/eth4
/network/device/loopback
/network/bridge/hotspot_bridge
/network/bridge/lan1
/network/bridge/new_hotspot_bridge
/network/wifi/ap/digi_ap1
/network/wifi/ap/digi_ap2
/network/wifi/ap/digi_hotspot_ap1
/network/wifi/ap/digi_hotspot_ap2
/network/wifi/ap/new_hotspot_ap1
/network/wifi/ap/new_hotspot_ap2
Current value:
(config network hotspot new_hotspot)>
b. Add the device:
(config network hotspot new_hotspot)> device /network/bridge/new_
hotspot_bridge
(config network hotspot new_hotspot)>
8. Set the authentication mode:
(config network hotspot new_hotspot)> auth value
(config network hotspot new_hotspot)>
where value is one of:
click_through: Requires each user to accept the terms and conditions.
n
local_shared_password: Requires each user to enter a password. This password is
n
validated locally on the LR54 device, and the password is the same for all users.
See
about configuring hotspot for local shared password authentication.
radius_shared_password: Requires each user to enter a password. This password is
n
validated by an external RADIUS server, and the password is the same for all users.
See
information about configuring hotspot for RADIUS shared password authentication.
radius_user: Requires each user to enter username and password credentials that are
n
established on an external RADIUS server. The credentials are validated by the RADIUS
server.
LR54 User Guide
Configure the hotspot to use local shared password authentication
Configure the hotspot to use RADIUS shared password authentication
Hotspot configuration
for information
for
342