Digi LR54 User Manual page 283

Hide thumbs Also See for LR54:

Table of Contents

(config)> network wifi ap digi_ap1 isolate_client true

Isolate Wi-Fi clients

access points from communicating with each other.

8. Set the password that clients will use when connecting to the access point:

(config)> network wifi ap digi_ap1 encryption key_psk2 password

9. (Optional) Change the Wi-Fi radio for the access point:

a. Show available radios:

(config)> network wifi radio ?

Additional Configuration

---------------------------------------------------------------------

b. Set the appropriate radio:

(config)> network wifi ap digi_ap1 radio wifi1

10. (Optional) Set the amount of time to wait before changing the group key.

The group key is shared by all in clients of the access point, and after a client has

disconnected, it will be able to use the group key to decrypt broadcast packets until the key is

(config)> network wifi ap digi_ap1 encryption group_rekey value

where value is any number of days, hours, minutes, or seconds, and takes the format number

For example, to set group rekey interval to ten minutes, enter either 10m or 600s:

(config)> network wireless ap digi_ap1 encryption group_rekey 600s

Increasing the time between rekeys can improve connectivity issues in noisy environments. To

disable group rekeys, set to 0. This will allow any client that has previously connected to see

all broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10

1. Assign the Wi-Fi access point to a LAN interface or to a bridge. See

Network (LAN)

The access point must be assigned to an active LAN, or a bridge that is assigned to an active

LR54 User Guide

for information about how to prevent clients connected to different

Wi-Fi1 radio

Wi-Fi2 radio

Configure a bridge

for more information.

Configure a Wi-Fi access point with personal security

Configure a Local Area