Digi LR54 User Manual page 290

Wi-Fi
4. Set the SSID for the appropriate access point:
(config)> network wifi ap digi_ap1 ssid my_SSID
(config)>
5. SSID broadcasting is enabled by default for the preconfigured access points. If SSID
broadcasting is disabled:
(config)> network wifi ap digi_ap1 ssid_broadcast true
(config)>
6. Set the security for the access point to wpa2:
(config network wifi ap new_AP)> encryption type wpa2
(config network wifi ap new_AP)>
7. (Optional) Determine whether to prevent clients that are connected to this access point from
communicating with each other:
(config)> network wifi ap digi_ap1 isolate_client true
(config)>
See Isolate Wi-Fi clients
access points from communicating with each other.
8. Set the IP address or hostname of the RADIUS server:
(config)> network wifi ap digi_ap1 encryption host_wpa2 hostname
(config)>
9. Set the secret key as configured on the RADIUS server:
(config)> network wifi ap digi_ap1 encryption key_wpa2 secret_key
(config)>
10. (Optional) Set the RADIUS server's port. The default is 1812.
(config)> network wifi ap digi_ap1 encryption port_wpa2 port
(config)>
11. (Optional) Change the Wi-Fi radio for the access point:
a. Show available radios:
(config)> network wifi radio ?
Additional Configuration
---------------------------------------------------------------------
----------
wifi1
wifi2
(config)>
LR54 User Guide
Configure a Wi-Fi access point with enterprise security
for information about how to prevent clients connected to different
Wi-Fi1 radio
Wi-Fi2 radio
290