Digi LR54 User Manual page 73

Hide thumbs Also See for LR54:
Table of Contents

Advertisement

Interfaces
4. Set the metrics for WAN1:
a. Click Network > Interfaces > WAN1 > IPv4.
b. For Metric, type 2.
c. Click IPv6.
d. For Metric, type 2.
5. Click Apply to save the configuration and apply the change.
The LR54 device is now configured to use the cellular modem WWAN, WWAN, as its highest priority
WAN, and its Ethernet WAN, WAN1, as its secondary WAN.
  Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the metrics for WWAN:
a. Set the IPv4 metric for WWAN to 1. For example:
(config)> network interface wwan ipv4 metric 1
(config)>
b. Set the IPv6 metric for WWAN to 1:
(config)> network interface wwan ipv6 metric 1
(config)>
LR54 User Guide
Wide Area Networks (WANs)
73

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tx64

Table of Contents