Digi LR54 User Manual page 269

Wi-Fi
6. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set transmit power for the radio:
a. Determine available radios:
(config)> network wifi radio ?
Additional Configuration
----------------------------------------------------------------------
---------
wifi1
wifi2
(config)> network wifi radio
b. Set the transmit power percentage for the appropriate radio:
(config)> network wifi radio wifi1 tx_power value
(config)>
where value is any integer between 1 and 100 and represents the percentage of transmit
power that the Wi-Fi module should use.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
LR54 User Guide
Configure the Wi-Fi radio's transmit power
Wi-Fi1 radio
Wi-Fi2 radio
269