How To Recover A Lr54 That Will Not Boot - Digi LR54 User Manual

Hide thumbs Also See for LR54:

Table of Contents

System administration

1. Log into the LR54 WebUI as a user with Admin access.

2. On the main menu, click System. Under Administration, click Firmware Update.

3. Click Duplicate firmware.

4. Click Duplicate Firmware.

Command line

1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54

local command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. Duplicate the firmware:

> system duplicate-firmware

How to recover a LR54 that will not boot

This section describes the process for recovering a LR54 device that cannot boot because both

firmware images stored in flash memory have become corrupted.

When a LR54 device is in this state, the device will continually reboot as it attempts to boot one of the

firmware images that are stored on the device. The LED state will be as follows:

WWAN Service

LR54 User Guide

Periodic blink as the device reboots

Off or Yellow or Green

Off or Green

Update system firmware