Mounting And Removing A Module On The Machine Controller; Mounting A 264If-01 Module - YASKAWA 264IF-01 User Manual

3.2 Mounting and Removing a Module on the Machine Controller

3.2.1 Mounting a 264IF-01 Module

3.2 Mounting and Removing a Module on the Machine Controller

This section explains the procedure for mounting and removing a 264IF-01 Module.
 These diagrams show the procedure using the LIO-01 Module, but the procedure is the same for the 264IF-01 Mod-
ule

3.2.1 Mounting a 264IF-01 Module

Use the following procedure to mount a 264IF-01 Module.
 Before replacing a 264IF-01 Module, remove the 264IF-01 Module that needs to be replaced referring to 3.2.2
Removing a 264IF-01 Module.
( 1 ) Preparation
1.
Backup the Programs.
Save the programs written to the Machine Controller in the personal computer using MPE720.
 MPE720 Ver. 7.: Open the project file and then select Online - Transfer - Read from Controller.
2.
Save in the Flash Memory.
Save the programs written to the Machine Controller in the flash memory using the MPE720.
 MPE720 Ver. 7.: Open the project file and then select Online - Transfer - Save to Flash.
3.
Remove the Machine Controller and Expansion Rack.
Turn OFF the power supply and remove all the cables connected to the Machine Controller or Expansion Rack
(MP2200 Base Unit). Then, remove the Machine Controller and Expansion Rack from the panel or rack, and
place them where there is sufficient space, such as on a work table.
( 2 ) Removing the Option Cover
If an Option Cover is attached to the slot into which the 264IF-01 Module is to be mounted, remove it using the follow-
ing procedure.
1.
Remove the Battery Cover.
<MP2200/MP2300/MP2200 Base Unit>
Pull the notch on the side toward you to remove the
battery cover.
3-4
<MP2310/MP2300S>
Insert a finger in the lug on the lower part of the bat-
tery cover as shown in the figure and remove the
battery cover.