Configuration Methods - Digi IX20W-PR User Manual

Firmware configuration
3. Set a new SSID for the digi_ap access point:
(config)> network wifi ap digi_ap ssid new_ssid
(config)>
4. Set a new pre-shared key:
(config)> network wifi ap digi_ap encryption key_psk2 new_key
(config)>
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configuration methods

There are two primary methods for configuring your IX20 device:
Web interface.
n
The web interface can be accessed in two ways:
Central management using the Digi Remote Manager, a cloud-based device management
l
and data enablement platform that allows you to connect any device to any application,
anywhere. With the Remote Manager, you can configure your IX20 device and use the
configuration as a basis for a Remote Manager configuration which can be applied to other
similar devices. See
Manager to manage and configure your IX20 device.
The local web interface. See
l
using the local web interface to manage and configure your IX20 device.
Note Changes made to the device's configuration by using the local web interface will not
be automatically reflected in Digi Remote Manager. You must manually refresh Remote
Manager for the changes to be displayed.
Web-based instructions in this guide are applicable to both the Remote Manager and the local
web interface.
n Command line.
A robust command line allows you to perform all configuration and management tasks from
within a command shell. Both the Remote Manager and the local web interface also have the
option to open a terminal emulator for executing commands on your IX20 device. See
the command line
configure your IX20 device.
In this guide, task topics show how to perform tasks:
IX20 User Guide
Central management
Using the local web interface
for more information about using the command line to manage and
for more information about using the Remote
for more information about
Configuration methods
Using
51