Configuration Methods - Digi Connect IT 4 User Manual

Firmware configuration
3. Set a new password for the admin user. The password must be at least eight characters long
and must contain at least one uppercase letter, one lowercase letter, one number, and one
special character.
(config)> auth user admin password new-password
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configuration methods

There are two primary methods for configuring your Connect IT 4 device:
Web interface.
n
The web interface can be accessed in two ways:
Central management using the Digi Remote Manager, a cloud-based device management
l
and data enablement platform that allows you to connect any device to any application,
anywhere. With the Remote Manager, you can configure your Connect IT 4 device and use
the configuration as a basis for a Remote Manager configuration which can be applied to
other similar devices. See
Remote Manager to manage and configure your Connect IT 4 device.
The local web interface. See
l
using the local web interface to manage and configure your Connect IT 4 device.
Note Changes made to the device's configuration by using the local web interface will not
be automatically reflected in Digi Remote Manager. You must manually refresh Remote
Manager for the changes to be displayed.
Web-based instructions in this guide are applicable to both the Remote Manager and the local
web interface.
Command line.
n
A robust command line allows you to perform all configuration and management tasks from
within a command shell. Both the Remote Manager and the local web interface also have the
option to open a terminal emulator for executing commands on your Connect IT 4 device. See
Using the command line
configure your Connect IT 4 device.
In this guide, task topics show how to perform tasks:

Web
Shows how to perform a task by using the local web interface.

Command line
Digi Connect IT® 4 User Guide
Central management
Using the local web interface
for more information about using the command line to manage and
Configuration methods
for more information about using the
for more information about
30