Configuration Mode; Enable Configuration Mode; Enter Configuration Commands In Configuration Mode - Digi IX20 User Manual

Command line interface
Parameters
-------------------------------------------------------------------------
-
enable
key
port
Additional Configuration
-------------------------------------------------------------------------
-
acl
mdns
> config service ssh
4. Lastly, display the allowed values and other information for the enable parameter:
> config service ssh enable ?
Enable: Enable the service.
Format: true, false, yes, no, 1, 0
Default value: true
Current value: true
> config service ssh enable

Configuration mode

Configuration mode allows you to perform multiple configuration tasks and validate the changes prior
to saving them. You can cancel all changes without saving them at any time. Configuration changes
do not take effect until the configuration is saved.

Enable configuration mode

To enable configuration mode, at the root prompt, enter the config command without any
parameters:
> config
(config)>
When the command line is in configuration mode, the prompt will change to include (config), to
indicate that you are currently in configuration mode.

Enter configuration commands in configuration mode

There are two ways to enter configuration commands while in configuration mode:
Enter the full command string from the config prompt.
n
For example, to disable the ssh service by entering the full command string at the config
prompt:
IX20 User Guide
Current Value
true Enable
[private] Private key
22 Port
Access control list
Configuration mode
1144