ABB AC500 V3 Hardware Manual page 517

E1...E4 d1 d2
Class Comp Dev
Byte 6 - Byte 3
Bit 6...7
Class Interface Device
1 2
)
4 14 1...10
11 / 12 ADR
4 14 1...10
11 / 12 ADR
Remarks:
1
)
2
)
3 )
4
)
State LEDs
During the power ON procedure, the module initializes automatically. All LEDs (except the
channel LEDs) are ON during this time.
2022/01/31
d3 d4
Mod Ch
Byte 4 Byte 5
Module Channel
3 4
) ) )
3 4...7
1...10
3 4...7
1...10
In AC500, the following interface identifier applies:
14 = I/O bus, 11 = COM1 (e.g. CS31 bus), 12 = COM2.
The FBP diagnosis block does not contain this identifier.
With "Device" the following allocation applies:
31 = module itself, 1...10 = expansion module 1...10, ADR = hardware address
(e.g. of the DC551)
With "Module" the following allocation applies depending on the master:
Module error: I/O bus or FBP: 31 = module itself; COM1/COM2: 1...10 = expan-
sion 1...10
Channel error: I/O bus or FBP = module type (1 = AI, 3 = AO); COM1/COM2:
1...10 = expansion 1...10
In case of module errors, with channel "31 = Module itself" is output.
3ADR010278, 3, en_US
Identifier
000...063
Err
Byte 6
Bit 0...5
Error
Identifier
8...15 4
8...15 7
Device specifications
I/O modules > Analog I/O modules
AC500 <− Display in
display
PS501
PLC
browser
FBP
diag-
nosis
block
Error message Remedy
Analog value over- Check
flow at an analog output
output value
Analog value under- Check
flow at an analog output
output value
517