Table of Contents
Advertisement
The module provides several diagnosis functions (see Diagnosis
nosis" on page 218).
The meaning of the LEDs is described in the section Status LEDs
LEDs" on page 219.
I/O configuration
The module itself does not store configuration data. It receives its parameterization data from
the master device of the I/O bus (CPU or communication interface module) during power-up of
the system.
Hence, replacing I/O modules is possible without any re-parameterization via software.
Parameterization
The arrangement of the parameter data is performed with Automation Builder software.
The parameter data directly influences the functionality of modules.
For non-standard applications, it is necessary to adapt the parameters to your system configura-
tion.
Name
Module ID Internal
Ignore
module
Parameter
length
Check
supply
1
) with CS31 and addresses smaller than 70, the value is increased by 1
2
) Value is hexadecimal: HighByte is slot (xx: 0...7), LowByte is index (1...n)
GSD file:
2022/01/31
The L+ connection of the DO571 and the 24 V supply of the CPU/communica-
tion interface module must be connected to the same 24 V power supply.
If the external power supply voltage via UP/ZP terminals fails, the I/O module
loses its configuration data. The whole station has to be switched off and on
again to re-configure the module.
Value
Internal
Value
1
6125
)
No
0
Yes
1
Internal
1
Off
0
On
1
3ADR010278, 3, en_US
Internal
Default
Value,
Type
WORD
6125
0x17ED
BYTE
No
(0x00)
BYTE
0
BYTE
On
0x01
Device specifications
I/O modules > Digital I/O modules
Ä Chapter 1.6.1.1.9.6 "Diag-
Ä Chapter 1.6.1.1.9.7 "State
Min.
Max.
0
65535
0
255
EDS Slot
Index
xx01
2
xx02
)
217
Hide quick links:
Advertisement
Table of Contents
