ABB AC500 V3 Hardware Manual page 317

Technical data of the digital outputs
Parameter
Number of channels per module
Distribution of the channels into groups
Connection of the channels
O0 to O7
O8 to O15
O16 to O23
O24 to O31
Indication of the output signals
Reference potential for all outputs
Common power supply voltage
Output voltage for signal 1
Output delay (0 -> 1 or 1 -> 0)
Output current
Rated value, per channel
Maximum value (channels O0 to O15)
Maximum value (channels O16 to O31)
Maximum value (all channels together)
Max. leakage current with signal 0
Rated protection fuse on UP
Demagnetization when inductive loads are
switched off
Switching frequency
With resistive load
With inductive loads
With lamp loads
Short-circuit proof / overload proof
Overload message (I > 0.7 A)
Output current limitation
Resistance to feedback against 24 V signals
Max. cable length
Shielded
Unshielded
The following drawing shows the circuitry of a digital output with the varistors for demagnetiza-
tion when inductive loads are switched off.
2022/01/31
Value
32 outputs (with transistors)
1 group of 32 channels
Terminals 1.0 to 1.7
Terminals 2.0 to 2.7
Terminals 3.0 to 3.7
Terminals 4.0 to 4.7
1 yellow LED per channel, the LED is ON if the
output signal is high (signal 1)
Terminals 1.9, 2.9, 3.9 and 4.9 (negative pole
of the process supply voltage, signal name ZP)
For all outputs: terminals 1.8, 2.8, 3.8 and 4.8
(positive pole of the process supply voltage,
signal name UP)
UP (-0.8 V)
On request
500 mA at UP = 24 V
4 A
4 A
8 A
< 0.5 mA
10 A fast
With varistors integrated in the module (see
figure below)
On request
Max. 0.5 Hz
Max. 11 Hz with max. 5 W
Yes
Yes, after ca. 100 ms
Yes, automatic reactivation after short-cir-
cuit/overload
Yes
1000 m
600 m
3ADR010278, 3, en_US
Device specifications
I/O modules > Digital I/O modules
317