ABB AC500 V3 Hardware Manual page 629

Connection of CANopen communication interface module CI581-CN:
AI0+
AI1+
AI2+
AI3+
AI-
UP +24 V
ZP 0 V
Fig. 100: Connection of the communication interface module CI581-CN
The module provides several diagnosis functions
on page 645.
For the measuring ranges that can be configured, please refer to the sections Measuring
Ranges
Ä Chapter 1.7.2.2.7 "Parameterization" on page 640.
The meaning of the LEDs is described in the section for the state LEDs
"State LEDs" on page 648.
Bus length The maximum possible bus length of a CAN network depends on bit rate (transmission rate)
and cable type. The sum of all bus segments must not exceed the maximum bus length
2022/01/31
For the open-circuit detection (cut wire), each analog input channel is pulled up
to "plus" by a high-resistance resistor. If nothing is connected, the maximum
voltage will be read in then.
Generally, analog signals must be laid in shielded cables. The cable shields
must be grounded at both sides of the cables. In order to avoid unacceptable
potential differences between different parts of the installation, low resistance
equipotential bonding conductors must be laid.
Only for simple applications (low electromagnetic disturbances, no high require-
ment on precision), the shielding can also be omitted.
2.0
+
-
2.1
+
-
2.2
+
-
2.3
+
-
2.4
2.5 AO0+
+
-
2.6 AO1+
+
-
2.7 AO-
PTC PTC
2.8
2.9
Ä Chapter 1.7.2.2.10 "Measuring ranges" on page 650 and Parameterization
3ADR010278, 3, en_US
Communication interface modules (S500) > CANopen
DI0 3.0
DI1 3.1
DI2 3.2
DI3 3.3
DI4 3.4
DI5 3.5
DI6 3.6
DI7 3.7
3.8
3.9
Ä Chapter 1.7.2.2.8 "Diagnosis"
Device specifications
4.0 DO0
4.1 DO1
4.2 DO2
4.3 DO3
4.4 DO4
4.5 DO5
4.6 DO6
4.7 DO7
3.8
UP3 +24 V
ZP 0 V
3.9
Ä Chapter 1.7.2.2.9
629