ABB AC500 V3 Hardware Manual page 618

Device specifications
Communication interface modules (S500) > CANopen
Parameter
Processor
Expandability
State display
Adjusting elements
Ambient temperature
Current consumption
Weight (without terminal unit)
Process supply voltages UP/UP3
Max. power dissipation within the module
Reference potential for all digital inputs and
outputs
Setting of the CANopen Node ID identifier
Mounting position
Cooling
Effect of incorrect input terminal connection
Required terminal unit
618
Rated value
Max. load for the terminals
Protection against reversed voltage
Rated protection fuse on UP/UP3
Galvanic isolation
Inrush current from UP (at power up)
Current consumption via UP (normal
operation)
Current consumption via UP3
Connections
3ADR010278, 3, en_US
Value
Hilscher NETX 100
CI58x can only be used on onboard CAN inter-
face and without any I/O expansion module
Ä Table 132 "CANopen" on page 617.
Module state: PWR/RUN, CN-RUN, CN-ERR,
E-ERR, I/O bus
2 rotary switches for generation of the node
address
System data AC500 Ä Chapter 2.6.1 "System
data AC500" on page 971
System data AC500 XC
"System data AC500-XC" on page 1023
UP: 0.2 A UP3: 0.06 A + 0.5 A max. per output
Ca. 125 g
24 V DC (for inputs and outputs)
10 A
Yes
10 A fast
CANopen interface against the rest of the
module
On request
0.2 A
0.06 A + 0.5 A max. per output
Terminals 2.8 and 3.8 for +24 V (UP)
Terminal 4.8 for +24 V (UP3)
Terminals 2.9, 3.9 and 4.9 for 0 V (ZP)
6 W
Negative pole of the supply voltage, signal
name ZP
With 2 rotary switches at the front side of the
module
Horizontal
Or vertical with derating (output load reduced to
50 % at 40 °C per group)
The natural convection cooling must not be
hindered by cable ducts or other parts in the
switchgear cabinet.
Wrong or no signal detected, no damage up to
35 V
TU509, TU510, TU517 or TU518
Ä Chapter 1.5.3 "TU517 and TU518 for com-
munication interface modules" on page 132
Ä Chapter 2.7.1
2022/01/31