ABB AC500 V3 Hardware Manual page 993

4
Fig. 191: Connect the wire to the spring terminal (steps 4 to 7)
1.
2.
3.
4.
5.
6.
7.
8.
Disconnection
1
Fig. 192: Disconnect wire from the spring terminal (steps 1 to 3)
2022/01/31
5
Side view (open terminal drawn for illustration)
The top view shows the openings for wire and screwdriver
Insert screwdriver (2.5 x 0.4 to 3.5 x 0.5 mm) at an angle, screwdriver must be at least 15
mm free of insulation at the tip
While erecting the screwdriver, insert it until the stop (requires a little strength)
Screwdriver inserted - terminal open
Strip the wire for 7 mm (and put on wire-end ferrule)
Insert wire into the open terminal
Done
2
3ADR010278, 3, en_US
System assembly, construction and connection
AC500 (Standard) > Connection and wiring
6
Screwdriver
3
7
Screwdriver
993