ABB AC500 V3 Hardware Manual page 859

Technical data of the digital inputs/outputs if used as inputs
Parameter
Number of channels per module
Distribution of the channels into groups
Terminals of the channels DC0 to DC7
Reference potential for all inputs
Indication of the input signals
Input type (according EN 61131-2)
Input delay (0->1 or 1->0)
Input signal voltage
Ripple with signal 0
Ripple with signal 1
Input current per channel
Max. cable length
*) Due to the direct connection to the output, the demagnetizing varistor is also effective at
the input (see figure) above. This is why the difference between UPx and the input signal may
not exceed the clamp voltage of the varistor. The varistor limits the voltage to approx. 36 V.
Following this, the input voltage must range from -12 V to +30 V when UPx = 24 V and from
-6 V to +30 V when UPx = 30 V.
Technical data of the digital inputs/outputs if used as outputs
Parameter
Number of channels per module
Distribution of the channels into groups
Terminals of the channels DC0 to DC7
Reference potential for all outputs
Common power supply voltage
Output voltage for signal 1
Output delay (0->1 or 1->0)
Output current
2022/01/31
Signal 0
Undefined Signal
Signal 1
Input voltage +24 V
Input voltage +5 V
Input voltage +15 V
Input voltage +30 V
Shielded
Unshielded
3ADR010278, 3, en_US
Communication interface modules (S500) > PROFINET
Value
8
1 group of 8 channels
Terminals 1.0 to 1.7
Terminals 1.9...3.9 (Negative pole of the supply
voltage, signal name ZP)
1 yellow LED per channel, the LED is ON when
the input signal is high (signal 1)
Type 1
Typ. 0.1 ms, configurable from 0.1...32 ms
24 V DC
-3 V...+5 V
> +5 V...< +15 V
+15 V...+30 V
Within -3 V...+5 V
Within +15 V...+30 V
Typ. 5 mA
> 1 mA
> 2 mA
< 8 mA
1000 m
600 m
Value
8
1 group of 8 channels
Terminals 1.0 to 1.7
Terminals 1.9...3.9 (negative pole of the supply
voltage, signal name ZP)
For all outputs terminal 3.8 (positive pole of the
supply voltage, signal name UP3)
UP3 (-0.8 V)
On request
Device specifications
859