ABB AC500 V3 Hardware Manual page 840

Device specifications
Communication interface modules (S500) > PROFINET
Terminal
2.1
2.2
2.3
2.4
2.5
2.6
2.7
2.8
2.9
3.0
3.1
3.2
3.3
3.4
3.5
3.6
3.7
3.8
3.9
840
Signal
DI9
DI10
DI11
DI12
DI13
DI14
DI15
UP
ZP
DO8
DO9
DO10
DO11
DO12
DO13
DO14
DO15
UP3
ZP
WARNING!
Removal/Insertion under power
The devices are not designed for removal or insertion under power. Because of
unforeseeable consequences, it is not allowed to plug or unplug devices with
the power being ON.
Make sure that all voltage sources (supply and process voltage) are switched
off before you
– connect or disconnect any signal or terminal block
– remove, mount or replace a module.
Disconnecting any powered devices while energized in a hazardous location
could result in an electric arc, which could create a flammable ignition resulting
in fire or explosion.
Make sure that power is removed and that the area has been thoroughly
checked to ensure that flammable materials are not present prior to proceeding.
The devices must not be opened when in operation. The same applies to the
network interfaces.
NOTICE!
Risk of damaging the PLC modules!
Overvoltages and short circuits might damage the PLC modules.
– Make sure that all voltage sources (supply voltage and process supply
voltage) are switched off before you begin with operations on the system.
– Never connect any voltages or signals to reserved terminals (marked with
---). Reserved terminals may carry internal voltages.
3ADR010278, 3, en_US
Description
Signal of the digital input DI9
Signal of the digital input DI10
Signal of the digital input DI11
Signal of the digital input DI12
Signal of the digital input DI13
Signal of the digital input DI14
Signal of the digital input DI15
Process voltage UP (24 V DC)
Process voltage ZP (0 V DC)
Signal of the digital output DO8
Signal of the digital output DO9
Signal of the digital output DO10
Signal of the digital output DO11
Signal of the digital output DO12
Signal of the digital output DO13
Signal of the digital output DO14
Signal of the digital output DO15
Process voltage UP3 (24 V DC)
Process voltage ZP (0 V DC)
2022/01/31