ABB AC500 V3 Hardware Manual page 444

Device specifications
I/O modules > Analog I/O modules
I/O configuration
The module does not store configuration data itself. It gets its parameterization data from the
master device of the I/O bus (CPU or communication interface module) during power-up of the
system.
That means replacing I/O modules is possible without any re-parameterization via software.
Parameterization
Firmware version
Firmware version > V2.0.0
The parameter data directly influences the functionality of modules.
For non-standard applications, it is necessary to adapt the parameters to your system configura-
tion.
Module: Module slot address: Y = 1...10
No.
1
2
3
4
5
6
444
If the external power supply voltage via UP/ZP terminals fails, the I/O module
loses its configuration data. The whole station has to be switched off and on
again to re-configure the module.
Name Value Internal
value
Module Internal 1515
ID
1 )
Ignore No 0
module
Yes 1
2 )
Param- Internal 34
eter
length in
bytes
Check Off 0
supply
On 1
Analog Default 0
data
format
Channel See
Ä Table 91 "Chann
configu-
ration
el configuration
on page 446
Input
channel
0
3ADR010278, 3, en_US
Configuration
The arrangement of the parameter data is per-
formed by Control Builder Plus/ Automation
Builder software.
Internal Default
value,
type
Word 1515
0x05eb
Byte No
0x00
Byte 34-CPU
34-FBP
Byte On
0x01
Byte Default
0x00
Byte Default
0x00
2
)"
Min. Max. EDS
Slot/
Index
0 65535 0x0Y01
not for
FBP
0 255 0x0Y02
0 1 0x0Y03
0x0Y04
0 19 0x0Y05
2022/01/31