ABB AC500 V3 Hardware Manual page 670

Device specifications
Communication interface modules (S500) > CANopen
Name
Substitute value
at output
Preventive
voltage feedback
monitoring for
DC0..DC7
Detect voltage
overflow at out-
puts
Remarks:
1
)
2
)
3
)
1.7.2.3.8 Diagnosis
Byte Number
1
2
3
670
Value
0 ... 65535
Off
On
2
)
Off
On
3
)
The parameter Behavior DO at comm. error is applied to DC and DO
channels and only analyzed if the failsafe mode is ON.
The state "externally voltage detected" appears if the output of a channel
DC0..DC7 is to be switched on while an external voltage is connected.
In this case, start-up is disabled while the externally voltage is con-
nected. The monitoring of this state and the resulting diagnosis message
can be disabled by setting the parameters to "OFF".
The error state "voltage overflow at outputs" appears if external voltage
at digital outputs DC0..DC7 and DO0..DO7 has exceeded the process
supply voltage UP3 (see 'Connections'
tions" on page 660). The according diagnosis message "Voltage over-
flow on outputs " can be disabled by setting the parameters to "OFF".
This parameter should only be disabled in exceptional cases as voltage
overflow may produce reverse voltage.
Description
Diagnosis byte, slot number 31 = CI582-CN (e. g. error at integrated 8 DI /
Diagnosis byte, module
number
Diagnosis byte, channel
3ADR010278, 3, en_US
Internal value Internal value,
type
0000h ... FFFFh WORD
0 BYTE
1
0 BYTE
1
Ä Chapter 1.7.2.3.3 "Connec-
Possible Values
8 DO)
1 = 1st connected S500 I/O module
...
10 = 10th connected S500 I/O module
According to the I/O bus specification passed
on by modules to the fieldbus master
According to the I/O bus specification passed
on by modules to the fieldbus master
Default
0
0x0000
Off
0x00
Off
0x00
2022/01/31