Replacing The Hard Drive - Thermo Scientific EASY-nLC 1200 Troubleshooting And Maintenance Manual

Replacing the Hard Drive

Thermo Scientific
❖ To install an flow sensor
1. Insert the new flow sensor behind the bracket.
2. Insert the two screws
and tighten the screws with a 2.5 mm hex wrench.
3. Connect the black cable to the flow sensor (see
4. Reconnect the nanoViper tubing to both ends of the flow sensor (see
page 93).
5. Replace the right side panel.
6. Turn on the EASY-nLC 1200 system, and wait one hour for the flow sensor to reach the
correct operating temperature.
7. Calibrate the new flow sensor by using the Flow Sensors script (see
on page 50).
Thermo Fisher Scientific supplies several versions of the hard drive. Order the appropriate
hard drive based on the computer box where you are replacing the hard drive. The
discontinued computer box has an RS 232 port
Figure 77. Comparison of computer ports
Discontinued computer box LC585
Replacing the hard drive requires these tools and materials:
Tools
2.5 mm hex wrench
Torx T-10 wrench
To replace the hard drive, follow these procedures:
1. "To remove the hard drive,"
2. "To install the hard drive"
(Figure 75 on page 94) that secure the flow sensor to the bracket,
(Figure
Replacement part
• LC586: compatible with obsolete computer box (P/N LC585)
• LC608: compatible with current computer box (P/N LC607)
next procedure
on page 98
5
Routine Maintenance
Replacing the Hard Drive
Figure 74 on page 93).
Figure 73
"Constant Pressure"
77).
Current computer box LC607
Troubleshooting & Maintenance Guide
on
95